1. Check if your IQOS 3 MULTI is turned on by pressing the power button for 1 second. 
Lights are showing at the bottom? You are ready to go. If not turn on the IQOS 3 MULTI by holding down the button for 4 seconds or charge your IQOS with the IQOS™ Power Adaptor and USB cable.

2. Rotate the IQOS 3 MULTI lid and insert the tobacco stick. Push it gently down to the filter line. Make sure you don't twist the tobacco stick.

3. Hold the button until it vibrates. The light will begin to pulse as your IQOS 3 MULTI heats up. 

4. Your IQOS 3 MULTI will then vibrate twice and the light will turn solid white. This means you’re ready to go! 

5. When the light begins to pulse and your device vibrates twice again, that means your IQOS 3 MULTI time is almost finished. 

6. When the light fades out, slide open the Cap and remove the used tobacco stick. Now you can use your IQOS 3 MULTI again whenever you want. 

1. Press the button on your IQOS 3 MULTI to check your battery level. 

2. If your IQOS 3 MULTI battery has run out of charge, plug it into an electrical outlet and charge it with the IQOS™ Power Adaptor and IQOS™ USB Cable. Check that the bar light is pulsing, since this confirms that your IQOS is charging.

3. When the bar light is full again, you’re ready to go!  

Keeping your IQOS 3 MULTI clean is important, especially if you want to get the optimal performance. Thankfully, the IQOS™ Cleaning Tool does most of the work for you: 

1. First, let the IQOS 3 MUTLI cool down for a few minutes.

2. Take the Cap off of your IQOS 3 MULTI. Tap the device to free any loose tobacco. 

3. Take the lid off of the IQOS™ Cleaning Tool. Gently insert it into your IQOS 3 MULTI and rotate only a few times.

4. After approximately 20 tobacco sticks, we advise using the IQOS™ Cleaning Stick. Do it gently and don’t forget to use it inside the IQOS™ Cap.